Flake & Chip Epoxy Flooring in Gainesville, FL
Color flake (also called chip) epoxy is the most popular residential garage floor system in America for good reason — it's stunning, slip-resistant, hides imperfections, and dries fast. Vinyl chips in custom color blends are broadcast into a wet epoxy basecoat to refusal, then locked under dual polyaspartic topcoats. The result is a floor that looks like terrazzo, lasts longer than the concrete underneath, and comes in any color combination you can dream up — from subtle gray-white-charcoal to bold orange-blue Gator pride.
Typical investment: $5–$8 per sq ft installed
Benefits of Flake & Chip Epoxy Systems
- ✓Chemical and stain resistant against oil, gasoline, brake fluid, and household cleaners
- ✓Up to 10x stronger than bare concrete with a 10,000+ PSI compressive strength rating
- ✓Seamless, non-porous surface that resists mold, mildew, and bacterial growth — ideal for Florida humidity
- ✓UV-stable topcoats that resist yellowing and fading from harsh Gainesville sun exposure
- ✓Easy-clean surface — hose off spills, sweep dust, no special maintenance required
- ✓Decorative options including metallic swirls, color chip flakes, quartz blends, and solid colors
Our Flake & Chip Epoxy Systems Installation Process
No shortcuts. Every step matters for a floor that lasts 15-20 years.
Diamond Grind Surface Prep
We mechanically diamond-grind your concrete to a CSP-3 profile, opening the pores so epoxy bonds permanently. This is the single most important step — skipped by every cheap competitor, and the reason their floors peel within 2 years.
Crack & Joint Repair
All cracks, pits, spalls, and control joints are routed and filled with a flexible polyurea repair compound, then re-ground flush so the finished floor is glass-smooth.
Moisture Barrier Primer
Florida concrete pushes moisture vapor 24/7. We apply a 100%-solids moisture-mitigating epoxy primer that bonds the system together and prevents osmotic blistering.
Basecoat & Decorative Layer
Your chosen color basecoat goes down at 12–15 mils, then we broadcast decorative chips, quartz, or metallic pigments to refusal while the coating is still wet.
Polyaspartic Topcoat
We finish with two coats of high-build polyaspartic topcoat for UV stability, abrasion resistance, and a deep, wet-look gloss that lasts a decade or more.
Common Use Cases
Ready to upgrade with Flake & Chip Epoxy Systems?
Free written estimate within 48 hours.
📞 (352) 555-0421Flake & Chip Epoxy Systems FAQs
What size flakes do you use?+
We default to 1/4-inch flakes for the best balance of appearance and slip resistance. We also offer 1/8-inch (subtle, modern look) and 1-inch jumbo flakes (terrazzo / bold look).
How many color blends are available?+
Over 40 stock blends plus fully custom mixes. Popular Gainesville blends: Gator (orange/blue/white), Coastal (tan/cream/charcoal), Storm (gray/black/white), and Espresso (browns/copper).
Are flake floors slippery?+
No — the broadcast flakes create natural micro-texture that's more slip-resistant than smooth epoxy or polished concrete, even when wet.
Will the flakes wear off over time?+
No. They're fully encapsulated under 20+ mils of polyaspartic topcoat. The flakes are protected the same way fish are protected by water — totally sealed in.
Is it good for outdoor patios?+
Yes with our UV-stable polyaspartic topcoat. We've installed flake systems on hundreds of screened lanais and covered patios across Gainesville.